go_away

Author Topic: PC to Radio interface  (Read 1987 times)

0 Members and 1 Guest are viewing this topic.

Offline spykid99Topic starter

  • Jr. Member
  • **
  • Posts: 30
  • Helpful? 0
PC to Radio interface
« on: January 22, 2009, 08:07:26 AM »
Hi
Im currently trying to interface a dissected walkie talkie that i have
I want it to send out a pre-recorded message from my speaker/headphone jack
I this possible and also i have two different walkie talkie types one runs on 49.860Mhz and the other on 145Mhz i think(because the marking is pointing towards a special switch box that has about 8 or so leads running in on one side and same on the other???
I want to transmit on the 145 Mhz one and and receive on the other one
Any help would be appreciated

Spykid99
"Do not worry about your difficulties in Mathematics. I can assure you mine are still greater." ~Albert Einstein

Offline fuzzyt

  • Jr. Member
  • **
  • Posts: 34
  • Helpful? 0
Re: PC to Radio interface
« Reply #1 on: January 22, 2009, 10:31:57 AM »
Unfortunately the frequencies on your walkie talkies will have to match.  You won't be able to xmit at 145MHz and receive that signal on 49.86MHz.  Its like a FM radio, you dial in the frequency you want to listen to.  Otherwise you would have to listen to them all at the same time.  :)

Offline spykid99Topic starter

  • Jr. Member
  • **
  • Posts: 30
  • Helpful? 0
Re: PC to Radio interface
« Reply #2 on: January 26, 2009, 01:21:36 AM »
Hi Again

What i mean is can i change their crystals so they can communicate ???
Ive heard you can't

Spykid99
"Do not worry about your difficulties in Mathematics. I can assure you mine are still greater." ~Albert Einstein

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,702
  • Helpful? 173
    • Society of Robots
Re: PC to Radio interface
« Reply #3 on: February 02, 2009, 07:59:13 AM »
It entirely depends on the rest of the circuitry attached to the crystal. Usually, no.

 


Get Your Ad Here

data_list