Author Topic: I2C pins on AxonII  (Read 2578 times)

0 Members and 1 Guest are viewing this topic.

Offline Aberg098Topic starter

  • Full Member
  • ***
  • Posts: 66
  • Helpful? 0
I2C pins on AxonII
« on: June 24, 2010, 08:45:25 AM »
Quick newbie question again:

So which pins on the AxonII corresponds to the SCL and SDA for the I2C connection?

I can see where I2C is labelled on the board, I also know that the outermost (ground) connection is not used.

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: I2C pins on AxonII
« Reply #1 on: June 24, 2010, 09:36:12 AM »
Have a look at the schematic, it'll be obvious. Unfortunately I couldn't cram all that text directly on the board :-\

Offline Aberg098Topic starter

  • Full Member
  • ***
  • Posts: 66
  • Helpful? 0
Re: I2C pins on AxonII
« Reply #2 on: June 24, 2010, 09:41:18 AM »
If you mean this schematic:
http://www.societyofrobots.com/axon2/downloads/axon2_schematic.pdf

I completely fail to see how this is obvious.

paulstreats

  • Guest
Re: I2C pins on AxonII
« Reply #3 on: June 24, 2010, 09:53:19 AM »
Under the "special headers" part, the first is the I2C header. SCL is in the middle and SDA is on the outside(the opposite one from the GND)

Offline Aberg098Topic starter

  • Full Member
  • ***
  • Posts: 66
  • Helpful? 0
Re: I2C pins on AxonII
« Reply #4 on: June 24, 2010, 09:57:38 AM »
Thank you!