Author Topic: I am a beginner on: Actuators!  (Read 3134 times)

0 Members and 1 Guest are viewing this topic.

Offline MeriemTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
I am a beginner on: Actuators!
« on: January 16, 2007, 06:29:54 AM »

I have just registered, so I am a New member ;)

I was just wondering if I could help regarding electromechanical Actuators, your experience

especially on ACTUATOR COUPLING issues.

I am runing experiement that involves that.

Thanks for helping and your time!

« Last Edit: January 16, 2007, 09:19:52 AM by Admin »

Offline Militoy

  • Expert Roboticist
  • Full Member
  • *****
  • Posts: 111
  • Helpful? 0
Re: I am a beginner on: Actuators!
« Reply #1 on: January 16, 2007, 01:42:35 PM »
What kinds (and sizes) of actuators does your experiment involve? I would venture a guess that most of the participants in this forum are using mainly R/C servos, linked using tie-rods, and small PM DC motors. Coupling issues become more critical, for both linear and rotary motion, as service loads and actuation distances are increased and in more harsh environments (such as underwater, or in dirty industrial areas).


Get Your Ad Here