Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: ***bacon*** on March 25, 2009, 09:09:42 PM
-
ok guys im a complete noob at robotics and this is a stupid question but what size and guage wire should i use? thanx ***bacon***'
-
*sigh* but just to help a noob out, 24-28gauge for smaller amperage. how many amps do you think will go through the wire? what will this be used for?
-
This will be used for the circutryin my 50$ robot
-
24-28 would be idle but you can use prettymuch anything but its just harder to solder on if its too big/too small.
-
depends on current going through the wire ;)
-
This will be used for the circutryin my 50$ robot
sorry admin, i went off this as i didnt think too much current would be going through these wires. sorry my bad :(