Author Topic: Sabertooth 2x60 Not turning both motors  (Read 3530 times)

0 Members and 1 Guest are viewing this topic.

Offline PraetorTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
    • @pump_upp - best crypto pumps on telegram !
Sabertooth 2x60 Not turning both motors
« on: November 05, 2016, 07:48:05 PM »
I am brand new here and I have searched for my answer but to no avail. 

I am running a 2x60 on 2 wheelchair motors.  Using 2 deepcycle 6v batteries in series in R/C mode Using a Dx6e and I think the 617 Rx.

I have double checked my wiring and have run every combination possible with no luck thus far.

Only one motor will turn at any time.  It acts normal when I push the stick around as if I'm turning or going back ward.  There is nothing from the other motor or M2.  Switch servo leads in my channels same thing.  Only M1 works.  What ever motor I put on M1 works and the other doesn't.  I do have voltage at the terminals of M2 but nothing.  I've tried everything I can think of but nope.  Not happening.

Any Ideas

 


Get Your Ad Here

data_list