Society of Robots - Robot Forum

Software => Software => Topic started by: dexringer on August 05, 2016, 02:36:48 AM

Title: connecting a lazer range finder to a linear actuator,
Post by: dexringer on August 05, 2016, 02:36:48 AM
I would likt to connect a lazer range finder to a linear actuator, and be able to prest the position/distance. IE if the wall is 60 feet away, you can set it to return to that position when 60 feet distance is achieved again. This would hold true for all distance/position measurements programmed in.
Can this be done? I am sure it is possible, I just dont know where to start. Any help would be greatly apreciated, and thank you for acceptance into your forum.