go_away

Author Topic: Design Problem!  (Read 1288 times)

0 Members and 1 Guest are viewing this topic.

Offline conTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
Design Problem!
« on: December 08, 2010, 08:52:15 AM »
Hi everyone,

I really need some assistance with a design probelem. I need to attach a black and decker drill to an end effector. I need to design some sort of pnuematic or manual system that will clamp a B&D drill so it can be connected to the power source and operations ran from the control panel. But i really need to come up with a design of a mechanism that will securly hold a black and decker whilst it drills.

Can anyone help?

Offline Conscripted

  • Robot Overlord
  • ****
  • Posts: 291
  • Helpful? 10
Re: Design Problem!
« Reply #1 on: December 08, 2010, 09:38:25 AM »
What are your limitations? Can you modify the drill? Do you need to be able to pick up and put down the drill autonomously? What is the end effector?

Conscripted

Offline Soeren

  • Supreme Robot
  • *****
  • Posts: 4,672
  • Helpful? 227
  • Mind Reading: 0.0
Re: Design Problem!
« Reply #2 on: December 08, 2010, 09:45:49 PM »
Hi,

Just make a holder out of eg. 10mm aluminum plate (or perhaps 5mm steel) that is formed so the drill can be bolted securely on to it and attach (weld?) a metal tube with some holes through it, that can be used to slide over a bar and locked in place with bolts going through it.
Should be a 2..4 hour job at the most.
Regards,
Søren

A rather fast and fairly heavy robot with quite large wheels needs what? A lot of power?
Please remember...
Engineering is based on numbers - not adjectives

 


Get Your Ad Here

data_list