Author Topic: need help on microswitch output  (Read 3668 times)

0 Members and 1 Guest are viewing this topic.

Offline blindmindTopic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
need help on microswitch output
« on: November 08, 2006, 12:39:36 PM »
i need help. i have connected two micrositches which act likeĀ  whiskers, to detect obstacle, to a basic stamps input ports. there is no problem when the output is giving value 1. it gives constant all the time. but, when 0....it fluctuates.not constant 0 instead a combination of 1 and 0 values. so, when this happen...at certain conditions,the motors seem to be stucked, not knowing which direction to go for.


i need to know what can i do to make the 0's to be all zeros instead of the combinations number of 0 and 1.pls help me. im in the state of giving up thinking after tried many attempst to fix it. :'(


thank you

Offline blindmindTopic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Re: need help on microswitch output
« Reply #1 on: November 08, 2006, 03:13:27 PM »
silly me....just ignore this post. the microswitch has three terminals NC, NO and Common.....

i totally forgot to connect either the NO or NC with the ground. after connctd, the 0s are always 0s. muahahahaha :D ;)

 


Get Your Ad Here