Author Topic: bluetooth  (Read 1131 times)

0 Members and 1 Guest are viewing this topic.

Offline SkwintTopic starter

  • Beginner
  • *
  • Posts: 4
  • Helpful? 0
« on: March 10, 2011, 02:44:28 PM »
I have an axon2 and I have found this:


It looks good - cheap, low power, small form factor, supports UART and most of the work happens on chip, so in principle I think I can attach it to my axon.  In reality I don't actually know.  The datasheets are a bit lacking in detail for me. ( http://www.datasheetdir.com/BCM2046+download )

Could anyone with a stronger grasp of electronics (I'm a software guy) tell me if that thing looks like it would wire up and work fairly easily, would I need to write drivers for it, or would I find it to be a complete nightmare with half a dozen break out boards and heaven knows what else needed as well?

Still learning here ;)
Thanks in advance!

Offline Soeren

  • Supreme Robot
  • *****
  • Posts: 4,672
  • Helpful? 227
  • Mind Reading: 0.0
Re: bluetooth
« Reply #1 on: March 10, 2011, 05:45:29 PM »

The datasheets are a bit lacking in detail for me.
Probably because it's a product brief and not a datasheet.
The page says "module only", so you'd probably have to wire it yourself (make your own break out, so to speak).

A rather fast and fairly heavy robot with quite large wheels needs what? A lot of power?
Please remember...
Engineering is based on numbers - not adjectives


Get Your Ad Here