Author Topic: lost in "50$ robot" limbo  (Read 1659 times)

0 Members and 2 Guests are viewing this topic.

Offline nortronTopic starter

  • Jr. Member
  • **
  • Posts: 7
  • Helpful? 0
lost in "50$ robot" limbo
« on: July 22, 2010, 06:08:26 PM »
hey guys, im making progress for the most part although im stuck on aligning servo's to 0.  I have avrisp2 programmer, i want to remove .hex file to re-install it but not sure which one it is , when i now click on the link it just comes up as non-coded jibberish.  any ideas?                                     


                                              thanks for reading
Logged

Offline SmAsH

  • Supreme Robot
  • *****
  • Posts: 3,959
  • Helpful? 75
  • SoR's Locale Electronics Nut.
Re: lost in "50$ robot" limbo
« Reply #1 on: July 23, 2010, 01:09:20 AM »
Can you right click the link and select "save target as"?
Logged
Howdy

Offline nortronTopic starter

  • Jr. Member
  • **
  • Posts: 7
  • Helpful? 0
Re: lost in "50$ robot" limbo
« Reply #2 on: July 23, 2010, 02:07:58 PM »
yeah, "save link as" gives me an icon.  I really dont think i installed it (if thats what your suppose to even do), everytime ive tried to open it gives jibberish..........




                                              thanks for reading
Logged

Offline Razor Concepts

  • Supreme Robot
  • *****
  • Posts: 1,856
  • Helpful? 53
    • RazorConcepts
Re: lost in "50$ robot" limbo
« Reply #3 on: July 23, 2010, 02:10:38 PM »
The hex file is just the data, to flash the code into the microcontroller (not really "install") you need to go through ponyprog (look deeper into the tutorial)
Logged
 

data_list