Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: lkik on October 14, 2010, 04:35:02 AM

Title: $50 robot programer header
Post by: lkik on October 14, 2010, 04:35:02 AM
I'm currently soldering the $50 together.. after starting and then stopping due to a lack of funds like 3 years ago
any way I'm a bit confused on which pin on the programmer header goes to the reset (pin 1 ) on the atmega8
Title: Re: $50 robot programer header
Post by: VegaObscura on October 14, 2010, 08:46:46 PM
Follow this schematic (http://www.societyofrobots.com/images/sbs_avr_schematic.png).

Pin 5.  Do take note of the way these pins are numbered.  It's not exactly the way you might expect them to be ordered.  Make sure you follow all the directions on this page (http://www.societyofrobots.com/step_by_step_robot_step3B.shtml) perfectly.