Society of Robots - Robot Forum

General Misc => Misc => Topic started by: jerrytom on October 08, 2010, 12:06:03 AM

Title: PROGRAMMING ATMEGA8
Post by: jerrytom on October 08, 2010, 12:06:03 AM
I'am using atmega8 for my project,i want to programme it in assembly language.
Is any tutorial or book available that is subjected to programming atmega8 ?
Title: Re: PROGRAMMING ATMEGA8
Post by: macdad- on October 09, 2010, 06:15:25 PM
Google is your friend.

And you should look at the Atmega8 datasheet for all the assembly commands. Once you have that just install AVR Studio 4 and your programmer.
Title: Re: PROGRAMMING ATMEGA8
Post by: Webbot on October 12, 2010, 10:00:37 AM
Also check out this 160 page ATmel instruction set reference http://www.atmel.com/dyn/resources/prod_documents/doc0856.pdf (http://www.atmel.com/dyn/resources/prod_documents/doc0856.pdf)