Author Topic: Stack Gear And Horn  (Read 2625 times)

0 Members and 1 Guest are viewing this topic.

Offline ajayreTopic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Stack Gear And Horn
« on: February 19, 2009, 11:44:14 PM »
Is there an easy way to attach both a gear and a horn to a servo? The gear would be closest to the servo housing followed by the horn on top.

I know that Servo City sells shafts with gears and hubs, but this is for an open source project so I want to keep the cost down and use commonly found items, rather that items from only one source.

thanks, Andy

Offline Razor Concepts

  • Supreme Robot
  • *****
  • Posts: 1,856
  • Helpful? 53
    • RazorConcepts
Re: Stack Gear And Horn
« Reply #1 on: February 20, 2009, 07:02:32 AM »
You could drill out a spur gear for RC cars, and screw it unto the underside of a servo horn. Then the servo horn screws into the servo normally.


Get Your Ad Here