go away spammer

Author Topic: I NEED HELP!  (Read 1671 times)

0 Members and 1 Guest are viewing this topic.

Offline CUrules12Topic starter

  • Jr. Member
  • **
  • Posts: 13
  • Helpful? 0
I NEED HELP!
« on: October 31, 2010, 07:46:53 PM »
Ok, so I bought the serial port to usb adapter because no computer in my house has a male header serial port

I plugged in the Dongle programmer...and Pony Prog wont write the source code!

What do I do?
Logged

Offline futurrobotech

  • Full Member
  • ***
  • Posts: 64
  • Helpful? 0
Re: I NEED HELP!
« Reply #1 on: October 31, 2010, 09:03:07 PM »
what do you mean ponyprog wont write the source code. Be more specific. Have you tried ALL of your USB ports(I believe i read this could cause a problem)
Logged

Offline CUrules12Topic starter

  • Jr. Member
  • **
  • Posts: 13
  • Helpful? 0
Re: I NEED HELP!
« Reply #2 on: October 31, 2010, 09:13:35 PM »
PonyProg pops up with a box that says Writing 0% and it stays at 0 %, and then the program goes to "Not Responding"
Logged

Offline futurrobotech

  • Full Member
  • ***
  • Posts: 64
  • Helpful? 0
Re: I NEED HELP!
« Reply #3 on: October 31, 2010, 09:19:57 PM »
okay i assume you're using usb.. try switch to a different usb port if you have multiple and try it in every port
Logged

Offline futurrobotech

  • Full Member
  • ***
  • Posts: 64
  • Helpful? 0
Re: I NEED HELP!
« Reply #4 on: October 31, 2010, 09:43:40 PM »
also post pics of the bottom of your robot board in case there is a bad connection
Logged
 

Get Your Ad Here