Author Topic: Rotation angle of Servo???  (Read 2535 times)

0 Members and 1 Guest are viewing this topic.

Offline ecaitsTopic starter

  • Beginner
  • *
  • Posts: 4
  • Helpful? 0
Rotation angle of Servo???
« on: August 13, 2015, 03:30:13 AM »
I am using Vigor VS 2 servo. As per data sheet, its output angle is >=170 degree and pulse traveling 800 to 2200 μsec.

When I give command of 90 degree to rotate, it rotate slightly more than 90 degree but when I give command of 85 degree then it is looking like exact 90 degree.

I have written simple program as written below.

Servo myservo;
int pos = 0;
void setup()
void loop()

What I require to modify to get the exact angle as per program code.

Thank You,


Offline cyberjeff

  • Full Member
  • ***
  • Posts: 114
  • Helpful? 7
Re: Rotation angle of Servo???
« Reply #1 on: August 15, 2015, 09:36:40 AM »
I'm going to broaden this a bit as I think this may be helpful to other.

So, where you servo winds up at is determined by a variety of factors, how the horn is mounted and how the servo is mounted among them. That and cheap servos are not perfect devices.

When you feed a servo, you want to adjust for that and also constrain it from travelling where it should not go (so it doesn't stall or break).

int desiredValue = 90;

int constrainMin = 30;
int constrainMax = 150;
int offset = -5;

int servoValue = constrain(desiredValue + offset, constrainMin, constrainMax);




Get Your Ad Here