Author Topic: 50 buck robo = beginner question  (Read 1926 times)

0 Members and 1 Guest are viewing this topic.

Offline nortronTopic starter

  • Jr. Member
  • **
  • Posts: 7
  • Helpful? 0
50 buck robo = beginner question
« on: July 10, 2010, 03:26:46 PM »
what up guys, ive got the avr isp 2 programmer and im looking for the program to help set my servo's to 0 degrees so i can make them spin freely (i tried the link in here and it was dead).  Also, my avr isp 2 just programs so i have to construct my micro-controller, and servos plug into that?                        durrrrrrrrrrrrrrrrrrrrrrr                      thanks for reading or replying

Offline Joker94

  • Supreme Robot
  • *****
  • Posts: 1,119
  • Helpful? 26
Re: 50 buck robo = beginner question
« Reply #1 on: July 11, 2010, 02:13:31 AM »
1st thing is that you have to have your microcontroller board finished to center your servos.

attached is the HEX file you need to center your servos

goodluck with it all, it will all work if you read the instructions well.

and if your still unsure about something, just post your question!
« Last Edit: July 11, 2010, 02:14:50 AM by Joker94 »

Offline Choco_liger

  • Full Member
  • ***
  • Posts: 81
  • Helpful? 3
Re: 50 buck robo = beginner question
« Reply #2 on: July 11, 2010, 03:21:04 AM »

 


Get Your Ad Here

data_list