Society of Robots - Robot Forum

Software => Software => Topic started by: NGuggemos on August 29, 2011, 08:40:06 AM

Title: Programming Axon II in Project Designer
Post by: NGuggemos on August 29, 2011, 08:40:06 AM
I'm programming the Axon II in project designer using Webbotlib.  When it asks for my battery and I'm using a switching regulator should I type the output voltage and current of the switching regulator or should I put the initial voltage of my battery?
Title: Re: Programming Axon II in Project Designer
Post by: Webbot on August 30, 2011, 07:24:56 AM
Yep - enter the output voltage and current of your supply - ie what you are going to 'plug in' to the AxonII.
Title: Re: Programming Axon II in Project Designer
Post by: NGuggemos on August 30, 2011, 08:41:50 PM
So I should enter the voltage and current after its regulated by the switching regulator?
Title: Re: Programming Axon II in Project Designer
Post by: Webbot on August 31, 2011, 09:36:13 AM
Yes
Title: Re: Programming Axon II in Project Designer
Post by: NGuggemos on September 01, 2011, 04:01:11 PM
ok thank you