Author Topic: Using a rotary encoder  (Read 6566 times)

0 Members and 1 Guest are viewing this topic.

Offline vinnygalboTopic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Using a rotary encoder
« on: February 16, 2017, 01:15:27 PM »

The only 5 pin rotary encoders I have encountered used 3 for 'encoder' part and the other 2 pins were for a momentary push button in the shaft; I haven't seen one that names a 'CLK' signal etc. I'm trying to see activity in the serial monitor. The encoder in question is an Accu-Coder.

Thank you in advance for any help.