Software > Software

Webbotlib Studio FBoot only works the first time!

<< < (2/6) > >>

Hero I:
My fuses match what the SoR's Axon II FAQ section says they should be set to.

Attached is an image capture of my Axon II's fuses settings.

One thing I noticed is that BOOTSZ and Fuse Register HIGH value are different than yours.

Webbot:
I think you should try changing the BOOTSZ to be the same as mine. (Wont cause any damage - after all that is how I have mine set).

I have a theory as to what is going on - and so if the above works then I'll explain it

Hero I:
I changed BOOTSZ to 512W_7E00 and the problem still exist.

Webbot:
Hmm - works fine for me  :) . I need to do some experimenting to see if I can reproduce your problem.
In the meantime make sure that:-

* Your hardware programmer is physically disconnected before using the bootloader
* When re-programming the board then leave it off for 5 to 10 seconds before re-programming via the bootloader
* Send me a copy of your project .hex file - just in case that is the problem (for any strange reason!)

Hero I:
Attached you will find the bootloader that I'm using and my program.

Navigation

[0] Message Index

[#] Next page

[*] Previous page