Society of Robots - Robot Forum

Software => Software => Topic started by: CUrules12 on October 31, 2010, 07:46:53 PM

Title: I NEED HELP!
Post by: CUrules12 on October 31, 2010, 07:46:53 PM
Ok, so I bought the serial port to usb adapter because no computer in my house has a male header serial port

I plugged in the Dongle programmer...and Pony Prog wont write the source code!

What do I do?
Title: Re: I NEED HELP!
Post by: futurrobotech on October 31, 2010, 09:03:07 PM
what do you mean ponyprog wont write the source code. Be more specific. Have you tried ALL of your USB ports(I believe i read this could cause a problem)
Title: Re: I NEED HELP!
Post by: CUrules12 on October 31, 2010, 09:13:35 PM
PonyProg pops up with a box that says Writing 0% and it stays at 0 %, and then the program goes to "Not Responding"
Title: Re: I NEED HELP!
Post by: futurrobotech on October 31, 2010, 09:19:57 PM
okay i assume you're using usb.. try switch to a different usb port if you have multiple and try it in every port
Title: Re: I NEED HELP!
Post by: futurrobotech on October 31, 2010, 09:43:40 PM
also post pics of the bottom of your robot board in case there is a bad connection