Author Topic: splitting power connection after ubec  (Read 1413 times)

0 Members and 1 Guest are viewing this topic.

Offline legitTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
splitting power connection after ubec
« on: December 10, 2014, 09:42:23 AM »
I bought a hexy the hexapod kit and I am planning on powering it with a 11.1v lipo but with a 5v ubec after the battery. The problem is that the control board (servotor) has 2 power inputs for logic and servo control.  I was planning on just soldering two dc jacks onto the ubec. Does anyone know if there is a "proper" way to split out connections from a single batter source? Or is soldering two DC jacks to the battery connector acceptable?

 


Get Your Ad Here

data_list