Society of Robots - Robot Forum

General Misc => Misc => Topic started by: nortron on July 10, 2010, 03:26:46 PM

Title: 50 buck robo = beginner question
Post by: nortron on July 10, 2010, 03:26:46 PM

what up guys, ive got the avr isp 2 programmer and im looking for the program to help set my servo's to 0 degrees so i can make them spin freely (i tried the link in here and it was dead).  Also, my avr isp 2 just programs so i have to construct my micro-controller, and servos plug into that?                        durrrrrrrrrrrrrrrrrrrrrrr                      thanks for reading or replying

Title: Re: 50 buck robo = beginner question
Post by: Joker94 on July 11, 2010, 02:13:31 AM

1st thing is that you have to have your microcontroller board finished to center your servos.

attached is the HEX file you need to center your servos

goodluck with it all, it will all work if you read the instructions well.

and if your still unsure about something, just post your question!

Title: Re: 50 buck robo = beginner question
Post by: Choco_liger on July 11, 2010, 03:21:04 AM

Also, here are other forum posts about this.

http://www.societyofrobots.com/robotforum/index.php?topic=6119.0 (http://www.societyofrobots.com/robotforum/index.php?topic=6119.0)
http://www.societyofrobots.com/robotforum/index.php?topic=10951.0 (http://www.societyofrobots.com/robotforum/index.php?topic=10951.0)
http://www.societyofrobots.com/robotforum/index.php?topic=10951.0 (http://www.societyofrobots.com/robotforum/index.php?topic=10951.0)

If you search "modify servo" you'll get loads of other topics about this.