Society of Robots - Robot Forum

Software => Software => Topic started by: lacanau on September 12, 2010, 08:32:16 AM

Title: servo code different if servos modified?
Post by: lacanau on September 12, 2010, 08:32:16 AM

HI everyone,
Cheers for the info!

I did have one little question. I acquired some servos that I was told are continuous and can turn the full 360.
Would the programming require any changes to account for this?
Cheers

Title: Re: servo code different if servos modified?
Post by: Admin on September 12, 2010, 08:50:35 AM

Nope, the basic code stays the same.

Title: Re: servo code different if servos modified?
Post by: amando96 on September 12, 2010, 09:15:12 AM

Instead of 90 being the neutral position, it will make the servo stop moving, 180 will be full speed in one way, and 0 will be full speed in the opposite way.