Society of Robots - Robot Forum

General Misc => Misc => Topic started by: klims on May 11, 2011, 06:20:21 PM

Title: Need some help identifying hardware/servos
Post by: klims on May 11, 2011, 06:20:21 PM

Hi guys,

I'm trying to identify some of the hardware from a robot that was made by someone else a while back. I'm looking to build something similar.
All the original images are here (http://www.1mm.jp/m/robo2006.html)

Specifically I'm trying to identify the servos being used. Here are some photos where you can see the profile of the servos.
Image 1 (http://www.1mm.jp/m/robo20060710b.jpg)
Image 2 (http://www.1mm.jp/m/robo20060806d.jpg)

My initial thought was that they were Kondo servos but I haven't been able to find out what Kondo servos were in use in 2006.


thanks for your help.

Title: Re: Need some help idetifying hardware/servos
Post by: macdad- on May 11, 2011, 06:26:29 PM

Any still visible serial numbers or something?
You could try to open up the servos and give us a pic of the PCB or any of the internals(There maybe a serial number on the inside back plate...)

Title: Re: Need some help identifying hardware/servos
Post by: klims on May 11, 2011, 06:40:03 PM

Sorry, maybe I didn't make it clear that this is just a robot I have seen on a website. It is the Omnizero.2 robot make back in 2006