Society of Robots - Robot Forum

Software => Software => Topic started by: darkjungle on September 04, 2007, 07:26:06 AM

Title: transferring prog
Post by: darkjungle on September 04, 2007, 07:26:06 AM

Can i transfer my programme using universal programmer(atmega 16).Which software to be used?

Title: Re: transferring prog
Post by: Admin on September 05, 2007, 07:17:54 AM

Check the datasheet of your 'universal programmer'. It will specifically say ATmega16 if you can use it. The datasheet should also tell you what software you will need.

This is the way I did it:
http://www.societyofrobots.com/step_by_step_robot_step4.shtml