Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: vidam on September 01, 2008, 01:05:17 PM

Title: serial on axon
Post by: vidam on September 01, 2008, 01:05:17 PM

Hi,

I'm already using the Rx/Tx port uart 2 for my sabertooth. Can I use uart0 for the blackfin. Do I have to change any setting to set that up?

Thanks,

Melanie

Title: Re: serial on axon
Post by: vidam on September 01, 2008, 01:06:30 PM

which pin is Rx/ Tx on UARt0?

Title: Re: serial on axon
Post by: Admin on September 01, 2008, 01:18:46 PM

Quote

I'm already using the Rx/Tx port uart 2 for my sabertooth. Can I use uart0 for the blackfin. Do I have to change any setting to set that up?

http://www.societyofrobots.com/axon/axon_function_list.shtml#uart

Quote

which pin is Rx/ Tx on UARt0?

T=Tx
R=Rx
G=ground

Title: Re: serial on axon
Post by: vidam on September 01, 2008, 01:27:24 PM

oops my bad... I didn't see the markings on the board for TRG.  :-[

Title: Re: serial on axon
Post by: vidam on September 01, 2008, 02:01:39 PM

Admin,

I added labels to your image to make it easier to discern TX and RX for people.

(http://i262.photobucket.com/albums/ii102/melvida/blackfin_jumper.jpg)


-Melanie