Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: aruna1 on September 18, 2008, 08:02:47 PM

Title: Home built programmer
Post by: aruna1 on September 18, 2008, 08:02:47 PM

can some one post a circuit diagram to make a PIC programmer that can be used to programme PIC16F877 using any pic programming software.
thanks

Title: Re: Home built programmer
Post by: ArcMan on September 19, 2008, 07:55:45 AM

Here ya go.  The famous "El-Cheapo" from Myke Predko.

http://www.rentron.com/Myke4.htm (http://www.rentron.com/Myke4.htm)

I built one.  Works great.  I'll sell you mine cheap, if you want.  I can't remember if I used the 40-pin socket or not.  I'll check.

Title: Re: Home built programmer
Post by: aruna1 on September 19, 2008, 11:35:16 AM

Quote from: ArcMan on September 19, 2008, 07:55:45 AM

Here ya go.  The famous "El-Cheapo" from Myke Predko.

http://www.rentron.com/Myke4.htm (http://www.rentron.com/Myke4.htm)

I built one.  Works great.  I'll sell you mine cheap, if you want.  I can't remember if I used the 40-pin socket or not.  I'll check.

thanks

Title: Re: Home built programmer
Post by: paulstreats on September 19, 2008, 03:31:29 PM

you can also use this one : http://www.instructables.com/id/Business-Card-PIC-Programmer/ (http://www.instructables.com/id/Business-Card-PIC-Programmer/)

You can use it to program in circuit so you dont have to keep swapping the pic out.
It works with ic-prog  ,  pony-prog etc.... to download you code