Society of Robots - Robot Forum

Software => Software => Topic started by: Jdog on December 08, 2008, 08:14:38 PM

Title: Hold_Servo. hex for Atmega 168
Post by: Jdog on December 08, 2008, 08:14:38 PM

Could someone please upload a holdservo.hex file for the atmega168 for me. I'm trying to figure out where I'm having problems. It would be greatly appreciated.

Title: Re: Hold_Servo. hex for Atmega 168
Post by: pomprocker on December 09, 2008, 02:01:29 PM

I think if you set the div by 8 fuse on the atmega168 and it runs at 1MHz that you might be ok?

but thats a good point, I modified my servos using an atmega8, but some people skip that and go straight for the atmega168