Society of Robots - Robot Forum

General Misc => Misc => Topic started by: AdvsNoob on December 27, 2008, 04:12:12 PM

Title: Roboduino Question
Post by: AdvsNoob on December 27, 2008, 04:12:12 PM

If i plug in my Roboduino 1.01 to my computer will the lights go on??? Oh ya and i do not have the Atmega168 chip in yet well because when i got it it was missing a pin...

Title: Re: Roboduino Question
Post by: airman00 on December 27, 2008, 04:48:54 PM

 Depends if you set the power jumper to be powered by the USB or powered by the battery - if you set it to be powered by the USB then yes, the power status LED will turn on.

Title: Re: Roboduino Question
Post by: AdvsNoob on December 27, 2008, 06:08:04 PM

how do i tell?  ;D

Title: Re: Roboduino Question
Post by: airman00 on December 27, 2008, 07:31:52 PM

Refer to this
http://curiousinventor.com/images/kits/roboduino/Roboduino_Color_revised2.jpg

Title: Re: Roboduino Question
Post by: AdvsNoob on December 27, 2008, 08:32:37 PM

oh lol

Title: Re: Roboduino Question
Post by: AdvsNoob on December 27, 2008, 08:36:49 PM

Quote from: AdvsNoob on December 27, 2008, 08:32:37 PM

oh lol

nothing ima go over it again hmmmm....

Title: Re: Roboduino Question
Post by: airman00 on December 27, 2008, 08:39:38 PM

did you finish soldering it yet?
Try connecting a battery to it , and set the power jumper to be on battery power. The power status LED should turn on.

Title: Re: Roboduino Question
Post by: AdvsNoob on December 29, 2008, 12:53:42 AM

Quote from: airman00 on December 27, 2008, 08:39:38 PM

did you finish soldering it yet?
Try connecting a battery to it , and set the power jumper to be on battery power. The power status LED should turn on.

Ya i finished soldering it.
Alright im gunna get battery when i get the Atmega