Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: hendrachubby on February 11, 2009, 07:10:52 PM

Title: Axon Power Supply
Post by: hendrachubby on February 11, 2009, 07:10:52 PM

Can i use 6 Volt adaptor for Axon Power Supply ?

Title: Re: Axon Power Supply
Post by: MaltiK on February 11, 2009, 07:15:02 PM

Quote

Absolute minimum required voltage is 5.35V, while the recommended battery voltage is 6V to 7.2V. Maximum voltage at 20V, however most servos cannot handle above 7.2V before being damaged.

Title: Re: Axon Power Supply
Post by: Jdog on February 11, 2009, 08:04:44 PM

Yes but make sure it's actually putting out 6 volts because most adaptors put out a few volts above what they say they do. If it is doing that you could put a 6 volt regulator in between the power supply and the axon.