Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: Joesavage1 on February 03, 2009, 01:28:54 AM

Title: brush water after soldering?
Post by: Joesavage1 on February 03, 2009, 01:28:54 AM

don't you brush water over the solder after its dried or something (if its water soluble) other wise use white spirit or alcohol depending on your solder.

Joe

Title: Re: brush water after soldering?
Post by: Admin on February 15, 2009, 05:00:45 AM

Only if you used acid based flux. I use 'no clean' flux cause I'm lazy :P

Title: Re: brush water after soldering?
Post by: Joesavage1 on February 15, 2009, 06:42:24 AM

Oh.. Ok Thanks

(PS: why u start new thread?)

Joe

Title: Re: brush water after soldering?
Post by: Admin on February 15, 2009, 07:16:20 AM

You were thread-jacking, asking a question unrelated to the thread you posted your question in :P

Title: Re: brush water after soldering?
Post by: Joesavage1 on February 15, 2009, 08:29:54 AM

oh ok; sorry i didnt realise.


Joe