Society of Robots - Robot Forum

Software => Software => Topic started by: denmaint on July 15, 2009, 07:06:09 PM

Title: Fanuc I/O
Post by: denmaint on July 15, 2009, 07:06:09 PM

I am a beginner here and with robots and I could use some help.  I have a Fanuc robot with an RJ2 controller.  I am trying to configure the Process I/O PCB.  I don't understand what the starting point means in the config menu.  I understand what the rack and slot configs are, just not the starting point.   Any help would be greatly appreciated.  Thanks

Title: Re: Fanuc I/O
Post by: Admin on July 21, 2009, 01:30:46 PM

Not entirely sure to what 'starting point' is referenced to in the manual . . .

I would assume thats the robot arm default position. For example, when you boot up the arm, where do you want to arm to always start at?