Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: hendrachubby on October 26, 2009, 07:31:33 AM

Title: AVR ISP MK II
Post by: hendrachubby on October 26, 2009, 07:31:33 AM

Hallo all,

I'm using AVR ISP MK II as my programmer, but i found that my microcontroller always reset when i unplug the programmer and run the uC itself. But when my programmer attached everything works fine. anyone have the same problem ? thx for the help

Title: Re: AVR ISP MK II
Post by: GearMotion on October 26, 2009, 11:32:18 AM

Connect a 10k ohm resistor from the microcontroller reset line to your Vcc line.

Title: Re: AVR ISP MK II
Post by: hendrachubby on October 26, 2009, 01:16:20 PM

owh ok, i'll try it, thx for the help