Author Topic: making photovore sensor question (Read 3450 times)

cooldog · « **on:** February 02, 2008, 09:06:36 PM »

ed1380 · « **Reply #1 on:** February 02, 2008, 09:08:04 PM »

2 questions for you.

1- which resistors did admin order?
2- which one did he use for the led?

cooldog · « **Reply #2 on:** February 02, 2008, 09:12:14 PM »

340ohm
1.62K

don't know which one he used for the LED

garriwilson · « **Reply #3 on:** February 02, 2008, 09:22:05 PM »

I think (70% sure) that I used the blue one. I can't check because it's covered in heatshrink. Wait for someone good to answer.

airman00 · « **Reply #4 on:** February 02, 2008, 09:23:46 PM »

340 ohm for the led sounds right

i use a 10K ohm resistor on my photocells though

ed1380 · « **Reply #5 on:** February 02, 2008, 09:55:55 PM »

340ohm
1.62K

don't know which one he used for the LED

look at the picture, read teh tutorial. worst case senario use this to decode it http://www.dannyg.com/examples/res2/resistor.htm

Society of Robots - Robot Forum