Author Topic: Hold_Servo. hex for Atmega 168  (Read 3169 times)

0 Members and 1 Guest are viewing this topic.

Offline JdogTopic starter

  • Robot Overlord
  • ****
  • Posts: 259
  • Helpful? 3
Hold_Servo. hex for Atmega 168
« on: December 08, 2008, 08:14:38 PM »
Could someone please upload a holdservo.hex file for the atmega168 for me. I'm trying to figure out where I'm having problems. It would be greatly appreciated.
Logged

Offline pomprocker

  • Supreme Robot
  • *****
  • Posts: 1,431
  • Helpful? 16
  • Sorry miss, I was giving myself an oil-job.
    • Nerdcore - Programming, Electronics, Mechanics
Re: Hold_Servo. hex for Atmega 168
« Reply #1 on: December 09, 2008, 02:01:29 PM »
I think if you set the div by 8 fuse on the atmega168 and it runs at 1MHz that you might be ok?

but thats a good point, I modified my servos using an atmega8, but some people skip that and go straight for the atmega168
Logged
 

SMF spam blocked by CleanTalk