Author Topic: ATX p/s to benchtop lab supply conversion  (Read 2568 times)

0 Members and 1 Guest are viewing this topic.

Offline pomprockerTopic starter

  • Supreme Robot
  • *****
  • Posts: 1,431
  • Helpful? 16
  • Sorry miss, I was giving myself an oil-job.
    • Nerdcore - Programming, Electronics, Mechanics
ATX p/s to benchtop lab supply conversion
« on: January 03, 2009, 11:04:40 PM »
I did this over the last couple days. Its really cheap, and is very handy. I would highly recommend making one if you have a few bucks and an extra power supply laying around. There are a ton of tutorials on the internet for them.



Logged

Offline airman00

  • Contest Winner
  • Supreme Robot
  • ****
  • Posts: 3,650
  • Helpful? 21
  • narobo.com
    • Narobo.com - Mechatronics and related
Re: ATX p/s to benchtop lab supply conversion
« Reply #1 on: January 03, 2009, 11:06:31 PM »
mmm nice... I made one myself about 3 months ago. Works surprisingly well.
Logged
Check out the Roboduino, Arduino-compatible board!


Link: http://curiousinventor.com/kits/roboduino

www.Narobo.com

Offline TrickyNekro

  • Contest Winner
  • Supreme Robot
  • ****
  • Posts: 1,208
  • Helpful? 15
  • Hardware and Firmware Designer
    • The Hellinic Robots Portal
Re: ATX p/s to benchtop lab supply conversion
« Reply #2 on: January 03, 2009, 11:19:50 PM »
Another one in the club... welcome!!!

And if you are handy, you can delay the power cut and test hobby motor and such which drain a hell in start up!!!

Cheers!!!
« Last Edit: January 03, 2009, 11:21:16 PM by TrickyNekro »
Logged
For whom the interrupts toll...
 

SMF spam blocked by CleanTalk