Author Topic: 50 dollar robot wire  (Read 4387 times)

0 Members and 1 Guest are viewing this topic.

Offline NOOBinDistressTopic starter

  • Robot Overlord
  • ****
  • Posts: 209
  • Helpful? 0
50 dollar robot wire
« on: April 19, 2007, 07:45:48 PM »
Hello. I am unsure what type of wire to use in the 50 dollar robot. It just says "wire" (it is in the part where you start soldering the "black wire". I was wandering if an elcectronics lab kit that I got for X mas  a couple of years ago from radio shack has the proper wire. They are thin and plastic coated. Will this work or is there a recommended wire type.thanks.

Offline Brandon121233

  • Contest Winner
  • Supreme Robot
  • ****
  • Posts: 320
  • Helpful? 0
  • "Genius is %1 inspiration and %99 perspiration"
Re: 50 dollar robot wire
« Reply #1 on: April 19, 2007, 08:07:30 PM »
Wire is generally rated by its gauge- AWG (American Wire Gauge), so weather it will work or not depends on that. Generally most prototyping is done with 22 AWG, but if its not carrying a lot of current , you can generally get away with 22-28 AWG. hope that helps you.
Hell, there are no rules here—we're
   trying to accomplish something.

                                                                              —Thomas Edison

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,702
  • Helpful? 173
    • Society of Robots
Re: 50 dollar robot wire
« Reply #2 on: April 21, 2007, 09:07:47 AM »
scroll down about halfway until you see a gauge - current chart

if you know the current, you will know if your wire is ok to use


Get Your Ad Here