Author Topic: 2-3 Cell Lipos Onto Axon MCU (Read 3980 times)

jj911 · « **on:** November 15, 2009, 10:38:46 AM »

Is it possible to plug a 2-3 cell lipo directly onto the axon mcu using the normal battery plugs? max volts would be 13v at 40amps 5000mah.

SmAsH · « **Reply #1 on:** November 15, 2009, 01:35:53 PM »

Yeah, you could plug that into the axon.
Although, you say "max 40 amps", what does this mean? You want to pull 40A through? You'd better not!

billhowl · « **Reply #2 on:** November 15, 2009, 08:00:32 PM »

No, Axon can only take max 10 Volts.

Admin · « **Reply #3 on:** November 15, 2009, 08:33:39 PM »

And only 13A per trace.

You can replace the large blue cap with a 20V cap to get the rating to 20V.

But not any higher.

Razor Concepts · « **Reply #4 on:** November 15, 2009, 10:01:05 PM »

Will the Axon vreg handle 12.6 volts well? IMO I would just use a good UBEC to step it down to 6 volts.

Admin · « **Reply #5 on:** November 15, 2009, 10:24:19 PM »

Will the Axon vreg handle 12.6 volts well? IMO I would just use a good UBEC to step it down to 6 volts.

The only limitation is the big cap. If you replace it with 20V, the Axon can handle it.

Just remember that servos can't handle 12.6V!

Society of Robots - Robot Forum